Ign Eng Off 0.4V, Engine running 0.4V-3.9VĠVolts for Self Test, 12V Normal operationĠ. Is located on the lower Row, Far Left, when the wiring connector is facing somewhere pretty.Īuto Transmission Reverse Signal and TachoĮngine running Trans in Reverse 900RPM, Trans in Gear 450Rpm The EB EEC-IV Wiring connector is the Standard Ford 60 Pin Connector, as used on the XF 4.1 EFI, EBII 4.0, and ED 4.0 EEC modules. See the DIYBOB main page for an application list. This one fits cars with a Ford EEC-IV 60 pin ECU. 4 Finally slide the kick panel backwards towards the back of the car. With the Ford EEC-IV (aka EEC4) 60 Pin PCM Connector, you can build professional adapter harnesses connecting the engine management system of your choice to a wide variety of Ford cars.3 Pull the back of the kick panel towards the transmission, to disengage the kick panel from the chassis.2 Remove the plastic plugs used to secure the plastic kick panel. Fiesta RS1800/RS Turbo - EEC IV Wiring diagram PATS circuits immobilised - As topic any wiring diagrams about ideally need pinouts on ECU ( for a N.1 Remove the 3 Retaining screws on the plastic door scuff plate, and remove the scuff plate.To remove the kick panel, and gain access to the EEC-IV module, you will need to complete the following. Newbie: Joined: Thu 6:19 pm Posts: 4 Hi, new here, and I am working using RomRaider for Ford EEC-IV chip 8061. The EEC-IV Module is located behind the Left Hand Side Kick Panel, On the passenger side of the vehicle, near the front seat. Post subject: New Plugin for Unsupported ECU - Ford EEC-IV. The above image describes the EEC-IV module Pin numbers, that are used on the Engine Control module. The information includes wiring connector pin-outs, wire colours, expected voltages, and wire feature. This document describes the pinouts, and wiring for the EEC-IV Engine Control Module, for the EB 8 cylinder Model Ford Falcon, Futura, Fairmont, Fairmont Ghia, Fairlane, LTD, and XR8 model Falcons.

Eec iv pinout